How to Sand End Grain Flooring as well as also also Why This kind of Should Be Left to a Professional Wood Floor Fitter
- September 10, 2017
- Posted by: marlenedubois
- Category: Home Health Aide Training
Well today’s D.I.Y. enthusiasts like to push the barrel as well as also also try brand new things. Here is usually a guide to help those who deem themselves fit.
Rule number one make sure you don’t bite off more than you can chew. Keep the area that will want to do to a minimum, so start off somewhere modest a cupboard or a hallway as well as also also then enlarge to a bigger room at a later date. Remember that will end grain floors requires up to ten times more sanding than normal grain floors. So rule number two make sure you have correct machinery as well as also also the correct sand papers to do the job. You will need a professional floor sander a self leveling belt machine 8-10 inch, a 6-8 inch edger sander as well as also also a screen sanding machine. When laying the floor try to make sure that will there is usually very little in height difference between blocks. This kind of will save a lot of time later when sanding. If there is usually over 2mm then This kind of will take a lot of time sanding so This kind of is usually best to make sure that will your sub floor is usually flat before installing.
OK so floor is usually down its flat not too many lumps as well as also also bumps you hold the correct machinery. Start off sanding with the belt floor sander using a 50 grit sand paper, go over the floor in all our directions. Always sand in a straight line through furthest point to furthest point start from the corner as well as also also come across the floor through one side of the room to the various other. Then turn round as well as also also do the opposite way far as you can reach always be careful of wires of course. Hopefully after This kind of the floor should feel flat to touch if not do the same again depending on how flat the floor was to start with This kind of could take up 10 to 15 more go’s, hopefully not. Then once the floor is usually flat, start sanding in a straight line along the length of the floor board usually you sand the same way with which This kind of was laid. You then repeat This kind of using a 80 grit sand paper. At the same time or after you can sand round the edge using a 50 grit, generating sure the edger is usually kept flat as well as also also the floor is usually also flat. Then change the edger to a 80 grit sand paper as well as also also repeat. Put a 100 grit sand paper on the belt sander as well as also also sand again with the length of the wood This kind of time try to be extra careful as well as also also sand in straight lines. Same with the edger change to 100 grit as well as also also gently sand tr no to dig the sander in as This kind of will mark.
We are nearly there two more sands to go nevertheless first the floor need to be filled using a mix as well as also also fill. We recommend a resin filler which is usually mixed with the saw dust through the edger sander. You should fill the floor twice at least as well as also also leave This kind of over night. Then from the morning sand over the floor with the belt sander as well as also also edger using a 0 grit sand paper. Make sure that will all the filler through the night before is usually removed or continue until This kind of is usually.Then buff the floor using a 150 grit screen on the screen sander.
OK generating sure that will’s This kind of all done all ready for you to apply a finish just make sure you wipe up all the dust using a tack cloth as well as also also then wipe the floor using a damp cloth just before you apply the finish. wish This kind of helps all you D.I.Y, nuts nevertheless beware This kind of can take 10 times more sanding than normal floors as the end grain surface is usually so hard.